Enter one or more keywords to search.
Wildcards - "*" and "?" are supported.
Search results for: Roofing-Bond
Results per page:
Category:
3 results found
https://completemarkets.com/Article/article-post/2119/INSURING-CONTRACTORS-BE-CAREFUL-IT-CAN-BE-A-BIG-E-O-HEADACHE/
... to find out through a claim that roofing is also being done, you could have a...hority limitations when the requested bonds are in excess of its bonding limits. This article original...
https://completemarkets.com/Article/article-post/1025/HOW-TO-AVOID-THE-12-MOST-COMMON-CAUSES-OF-BROADCAST-TOWER-LOSS/
...at least four 10-foot rods must be bonded to the tower base and in contact wit...
https://completemarkets.com/company/CompleteMarkets/Articles/content-package/IMMS-Library/TabCategory/article-post/1025/HOW-TO-AVOID-THE-12-MOST-COMMON-CAUSES-OF-BROADCAST-TOWER-LOSS/
... the tower, i.e., microwave dishes or antennas. A failure to install central source security systems, such as smoke detectors, motion detectors, and fire extinguishing systems. A failure to implement policies for regular equipment monitoring. 12. MANAGEMENT'S REFUSAL TO BELIEVE THAT A LOSS OF SIGNAL CAN OCCUR. With all the pressing daily issues of running a station, it is easy to neglect fixing the roof when it isn't raining. In the final analysis, neglect is perhaps the major cause of unnecessary loss. The broadcast signal is the station owner's greatest asset. If the signal fails, the value of the station can decline in a matter of hours. Other stations will instantly seize the opportunity to lure both the advertisers and audience away from the beleaguered station. One's goal should be to act ... possibility of lightning losses. Here is a checklist to help minimize tower damage by lightning. Lightning rods should project well above the tower beacon. Use binoculars to verify that the rods are in place and in good condition since severe lightning hits may vaporize them. Guy wire anchor points should be grounded to the nearest radial by copper strap. For grounded towers, at least four 10-foot rods must be bonded to the tower base and in contact with the groundwater table. Soil must be tested to determine conductivity. For insulated towers, the ball gap should be clear of debris so that the bare metal is exposed. Insulated towers should have a static drain choke connected between the feedline and the station ground. Insulated towers should have two 12-foot loops in the feedline between the tower and the transmitter housing ...